UltraGlow G33R-1 Zero Clearance Rear Vent Direct Vent Gas Fireplace
24
FLUSH LOUVERS
1)
Install each top louver by clipping the louver
lip onto the Top Louver Bracket.
2)
Install the bottom louver by folding the louver
down and then sliding the Bottom Louver
bracket down onto the 2 pins on the base
of the unit (diagram 1). Secure with 1 screw
as per diagram 2.
Diagram 1
Diagram 2
Diagram 3
Diagram 2
Use the hook to pull the spring out until you
can put the hook into the slot on the bottom
door bracket. Repeat for 2nd spring. See
diagram 3.
To remove the fl ush door, reverse the above
steps.
INSTALLATION
Diagram 1
FLUSH DOOR
The standard fl ush door
comes with a black
frame. To install the frame, simply hook the top
door fl ange onto the top of the unit and swing
the door towards the unit, diagram 1. Be care-
ful that the glass gasket does not roll up; there
must be a gap between the gasket and the door
lip to ensure that the door sits securely on the
unit. Diagram 2.
NOTE: This unit
is only approved
for use with tem-
pered glass.
Optional Flush Trim
Attach the round magnets to the back of the top
trim piece and to the bottom trim piece, then at-
tach trim to the top and bottom of Flush door.
Note: Top and bottom louvers are different.
