UltraGlow G33R-1 Zero Clearance Rear Vent Direct Vent Gas Fireplace
20
GAS LINE
INSTALLATION
The gas line can be brought through either the
right or the left side of the appliance. The gas
valve is situated on the right hand side of the
unit and the gas inlet is on the right hand side
of the valve.
Note: If the gas line is being installed from
the left side, be sure to leave room to
accommodate servicing of the fan.
The gas line connection may be made of rigid
pipe, copper pipe or an approved fl ex connec-
tor. (If you are using rigid pipe, ensure that the
valve can be removed for servicing.) Since some
municipalities have additional local codes it is
always best to consult with your local authorities
and the CAN/CGA B149 installation code.
For USA installations follow local codes and/or
the current National Fuel Gas Code, ANSI
Z223.1.
When using copper or fl ex connectors use only
approved fi ttings. Always provide a union so
that gas lines can be easily disconnected for
servicing. Flare nuts for copper lines and fl ex
connectors are usually considered to meet this
requirement.
Important: Always check for gas leaks with a
soap and water solution or gas leak detector.
Do not use open fl ame for leak testing.
INSTALLATION
Note: Output capacity - The effi ciency rating
of the appliance is a product thermal
effi ciency rating determined under
continuous operating conditions and
was determined independently of any
installed system.
Vent height may or may not change
your effi ciency ratings.
G33R-1 SYSTEM DATA
For 0 to 4500 feet altitude
Burner Inlet Orifi ce Sizes:
Natural Gas Propane
Burner
#49 #56
Max. Input Rating
- Natural Gas
15,000 Btu/h
- Propane
15,000 Btu/h
Min. Input Rating
-Natural
Gas
8,996 Btu/h
-Propane
7,819
Btu/h
Output Capacity
Natural
Gas
11,340
Btu/h
Propane
11,115
Btu/h
Supply Pressure
Natural Gas
min. 5.0" w.c.
Propane
min.
12.0"
w.c.
Manifold Pressure (High)
Natural Gas
3.8" +/- 0.2" w.c.
Propane
11" +/- 0.2" w.c.
Log Set
Ceramic fi bre, 4 per set.
Vent System:
Simpson Dura-Vent Direct
Vent System or UltraGlow Direct Vent System
(Flex)
HIGH ELEVATION
This unit is approved in Canada for altitude 0
to 4500 ft. (CAN1 2.17-M91) with the orifi ce
supplied.
