UHV Design MD40 Series, Инструкция по эксплуатации товара

Страница: 27 / 56

MD40 PRODUCT INSTRUCTION MANUAL
MD40 Page 27 of 56 Author: N.Carapiet | Revision: 1.1
STAGE 3 | Re-fitting the Drive Thimble and Motor Assembly
Refitting the Drive Thimble
1. Push Drive Thimble over the Flange Assembly (take care when re-coupling the magnets –
the magnetic coupling may cause a sudden movement)
2. Replace Bearing Cap and M3 grub screws
3. Replace the actuator drive housing. The housing must be correctly orientated using the
alignment screw on the flange and the cut out in the actuator housing bore without the
additional cut-out.
4. Replace Thimble Cover and tighten 2 x Actuator Housing Screws
Actuator Housing Screws
3 x M3 Grub Screws
Bearing Cap
Drive Thimble