Ugur UDF 3 SL, Руководство по эксплуатации

Страница: 42 / 212

EN
CAUTION!
In very humid environments, ensure that floor and wall of the place where the freezer is located, is not affected by
water; against discharge water overflow danger.
In installations performed by Authorized Uğur Service, Authorized Uğur Service shall inform the consumer on the
suitable place for installation and make suggestion, but the consumer shall give the final decision on where the
installation will be made. This above mentioned process shall also be stated on the relevant installation form by
Authorized Uğur Service. In case of any loss arising from the place of installation of the product according to the
final decision given by the consumer, all responsibility related to such loss shall belong to the consumer.
C- INSTALLATION OF YOUR DEEP FREEZER
Selecting the place of installation
Ürününüzün sorunsuz bir şekilde çalışması için çalışacağı ortam çok önemlidir. Çalışma ortamını seçerken,
• The operating environment of the product is very important for the smooth operation of your product. While selecting
the operating environment,
• Do not place your product exposed to outdoor environment (on the street, avenue, roof, balcony etc.)
• Place the product at least one (1) meter away from heat resources (stove, radiator, electric heater etc.) (Picture 1)
• Do not place it opposite to the air conditioner chutes, under fans and direct door and window openings. (Picture 2)
• Do not expose to direct sunlight. Operation ratio will increase if sunlight comes to the freezer’s glass. That means an
increase in the energy consumption.
• Be careful for not obstructing lower shutter of the product with materials such as cardboard, box etc. for a proper cooling.
• Air intake and outlet must absolutely be fluent and free for proper operation of the compressor section of your product.
• While approaching your product to the wall, be careful that there is a gap of 150 mm (15 cm) between the wall and back
of your freezer.
Your cooler gives the best cooling performance according to the climate condition under the conditions given below.
Therefore, be careful that the temperature of the environment where your cooler will operate is at these levels.
In Domestic Products:
Climate Class Acceptable Ambient Temperature
Class T +16 °C to 43 °C
Class ST +16 °C to 38 °C
Class N +16 °C to 32 °C
Class SN 10 °C ile 32 °C
Climate Class of your product
is indicated on the technical
specification label on the
product.
PICTURE 1 PICTURE 2
42