UGSI Encore 700, Руководство по эксплуатации и обслуживанию

Страница: 42 / 125

CF.440.400.001.IM.0417
ENCORE
®
700 METERING PUMP
26
3.1 Preparation for Operation
a. Fill the solution container with solution.
WARNING: TO AVOID POSSIBLE SEVERE PERSONAL INJURY, USE
EXTREME CARE TO AVOID CONTACT WITH THE MATERIAL.
CONSULT YOUR CHEMICAL SUPPLIER FOR INSTRUCTIONS IN
THE PREPARATION OF SOLUTIONS AND THE HANDLING OF
CHEMICALS.
NOTE: Unless otherwise indicated, drawings referenced in this section are
located in Section 5.
b. Remove the plug on top of the gearbox and replace it with breather cap (26,
Dwg., 440.400.001.020A).
NOTE: Depending on the method of shipment, the pump may have been
shipped with the gearbox already fi lled with oil. If not, the oil has been
shipped separately. Be sure that the gearbox has been fi lled properly before
operating the pump.
CAUTION: To avoid possible severe damage to the pump
mechanism, do not run the pump without the gearbox fi lled with oil.
The oil level must be up to the oil check hole.
c. Refer to Table 1.3 (in Section 1) to identify the belt location on the pulley to
obtain the desired feed rate. Pumps delivered from the factory will have the
belt located on the fi rst step (top step of the pulley), which is the maximum
speed setting. Install the belt guard before operating the equipment.
WARNING: TO AVOID POSSIBLE SEVERE PERSONAL INJURY, DO
NOT RUN THE PUMP WITH THE BELT GUARD REMOVED.
d. Start the motor and operate the pump at a stroke setting of 100% of the scale
until it is primed and ready for operation. The pump is designed to self-prime
under a no backpressure condition; however, if diffi
culty is encountered in
priming, check that the suction valve is not adhering to the suction valve
seat. Refer to Section 4 - Service if the pump does not prime.
3.2 Starting and Stopping the Pump
Turn the power supply to the pump on or off as needed.
!
!
!