TOBY-L1 and MPCI-L1 series - System Integration Manual
UBX-13001482 - R04
Advance Information
Design-in
Page 67 of 90
MPCI-L1 series modules are equipped with two Hirose U.FL-R-SMT RF receptacles for
ANT1
/
ANT2
ports, which
require a suitable mated RF plug from the same connector series as the examples listed in Table 17.
To mate the connectors, the mating axes of both connectors must be aligned. The "click" will confirm the fully
mated connection. Do not attempt to insert on an extreme angle: insert the RF plug connectors vertically into
the
ANT1
/
ANT2
RF receptacles of the modules, as described in Figure 42.
Correct
Wrong
Figure 42: Precautions during RF connector mating
To unplug the RF cable assembly it is encouraged to use a suitable extraction tool for the RF connector, such as
the Hirose U.FL-LP-N or the Hirose U.FL-LP(V)-N extraction jig, according to the RF cable assembly type used.
Hook the end portion of the extraction jig onto the connector cover and pull off vertically in the direction of the
connector mating axis, as described in Figure 43.
Extraction Jig
RF Cable Assembly
U.FL Receptacle
Figure 43: Precautions during RF connector extraction
Any attempt to unplug the RF connectors by pulling on the cable assembly without using a suitable extraction
tool may result in damage and affect the RF performance.
Do not forcefully twist, deform, or apply any excessive pull force to the RF cables or damage the RF connectors,
otherwise the RF performance may be reduced.
