Ubiquiti airFiber AF-11FX, Руководство пользователя

Страница: 31 / 56

25
Chapter 6: Network Tab airFiber AF-11FX User Guide
Ubiquiti Networks, Inc.
Chapter 6: Network Tab
The Network tab allows you to configure settings for the
management network. There are two ways to access the
airFiber Configuration Interface:
•
Management Port Enabled by default. Use a direct
connection to the Management port for out-of-band
management.
• In-Band Management Enabled by default. In-band
management is available through the local Data port or
the Data port at the other end of the link.
The Management port and in-band management share
the default IP address of 192.168.1.20 .
Test Changes To try the changes without saving them,
click Test Changes . A new message appears. You have two
options:
•
Apply
To immediately save your changes, click
Apply
.
• Discard To cancel your changes, click Discard . If you
do not click Apply within 180 seconds (the countdown
is displayed), the AF-11FX radio resumes its earlier
configuration.
Revert Changes To cancel your changes, click
Revert Changes .
Save Changes To save your changes, click Save Changes .
Management Network Settings
In-Band Management Enabled by default. In-band
management is available through the local Data port or
the Data port at the other end of the link.
Note: If In-Band Management is enabled, ensure
that each airFiber X radio in a link has a unique
IP Address. If the airFiber X radios use the same IP
Address
, you may lose access via the Data ports.
Management IP Address The airFiber X radio can use
a static IP address or obtain an IP address from its DHCP
server.
•
DHCP Keep the default, DHCP , to use DHCP reservation
on your router to assign a unique IP Address . The local
DHCP server assigns a reserved IP address, gateway IP
address, and DNS address to the airFiber X radio.
Note: If you select the DHCP option, ensure that
you use DHCP reservation because if you do not
know the IP address, then the only way to manage
the airFiber X radio is to reset the airFiber X radio
to its factory default settings. (Press and hold
the
Reset button for more than five seconds.)
Its default Management IP Address is reset to
192.168.1.20 .
- DHCP Fallback IP Specify the IP address the
airFiber X radio should use if a DHCP server is not
found.
- DHCP Fallback Netmask Specify the netmask the
airFiber X radio should use if a DHCP server is not
found.
• Static Assign static IP settings to the airFiber X radio.