Ubiquiti airFiber AF-11FX, Руководство пользователя

Страница: 15 / 56

9
Chapter 2: Installation airFiber AF-11FX User Guide
Ubiquiti Networks, Inc.
a. For the Management IP Address option:
‑ DHCP Keep the default, DHCP, to use DHCP
reservation on your router to assign a unique
IP Address.
‑
Static
Change the IP Address, Netmask, and other
settings to make them compatible with your
network.
b. Click Save Changes.
11. Disconnect the Ethernet cables from the MGMT and
DATA ports on the AF‑11FX. Configuration of the
AF‑11FX radio is complete.
Repeat the instructions in the airFiber Configuration
section on the other AF‑11FX radio.
Hardware Installation
Install a Ground Wire
1. Remove the nut from the Ground Bonding Point located
on the back of the AF‑11FX, near the lower‑right corner.
Ground
Bonding
Point
2. Attach a ground wire (min. 10 AWG or 5 mm
2
) to the
lug and replace the nut to secure the wire.
3. At the installation site, secure the other end of the
ground wire to a grounded mast, pole, tower, or
grounding bar.
WARNING: Failure to properly ground your
airFiber X radio will void your warranty.
Note: The ground wire should be as short as
possible and no longer than one meter in length.
Mount to the airFiber X Antenna
Follow the instructions in this section to mount the
AF‑11FX radio to an airFiber X AF‑11G35 antenna:
1. Attach an RF Cable to an RF connector labeled H
or V.
Then slide the silicone boot over the RF connector to
protect it.
Note: For SISO mode, use the RF connector
(H or V) as determined by your licensing. Keep
the other RF connector covered with the
included Metal Cap.
If using MIMO mode, remove the cap over the second
RF connector (V
or H) and attach an RF Cable. Then slide
the silicone boot over the RF connector to protect it.
H Connector V Connector
2. Attach the AF‑11FX radio to the antenna by aligning
the four tabs on the back of the radio with the slots of
the radio mount. Then slide the radio down to lock it
into place.