16
Chapter 2: Installation
airFiber
®
AF5/AF5U User Guide
Ubiquiti Networks, Inc.
Using the Audio Tone
Before You Begin
Create your own cable adapter to connect the
Aux
port
to your headphones or other listening device. The cable
adapter requires two items:
• An RJ-12 cable with an RJ-12 connector
• A cable with a 3.5 mm, female, stereo phono jack (mono
jack is acceptable)
1. Attach the wire from pin 6 of the RJ-12 cable to the
return or shield wire of the 3.5 mm jack.
2. Attach the wire from pin 5 of the RJ-12 cable to both
the left and right channel wires of the 3.5 mm stereo
phono jack.
Note:
For a mono jack, connect the wire from pin 5
to the + wire of the mono jack.
RJ-12 Connector
Return/Shield
Left/Right
Channel
Wire to Pin 6
Wire to Pin 5
Pin
Audio Jack
6
5
4
3
2
1
Pinouts from RJ-12 to 3.5 mm Stereo Phono Jack
Note:
Wire colors may vary on RJ-12 cables.
Establishing a Link
Adjust the positions of the
Master
and the
Slave
to
establish a link.
Note:
The
Master
must be aimed first at the
Slave
because the
Slave
does not transmit any RF signal
until it detects transmissions from the
Master.
1. Ensure that the following bolts and nuts are loose:
• Four
Pre-Installed M10x25 Flanged Bolts
on the
airFiber radio (two on each side)
• Four
M10 Hex Nuts
used to lock the elevation
alignment on the
Upper Mount Bracket
(two on
each side)
2. Ensure that the pole mount is snug yet the four
M10
Hex Nuts
attaching the
Pole Clamps
are loose enough to
allow rotation around the pole for azimuth alignment.
