UAZ UAZ-31512, Инструкция по эксплуатации

Страница: 27 / 113

27
Prime the carburettor by means of the fuel pump hand
primer.
Starting from Cold at 0 °Ñ and Above.
Shift the gearshift lever in the neutral.
Press the throttle valve control pedal (the accelerator pedal)
several times.
Disengage the clutch and switch on the ignition and the
starter. Switch on the starter for 5 s maximum. Intervals between
starting attempts should be at least 10-15 s.
(It is not recommended to switch on the starter for more than
three times in succession, stop starting, check the engine, detect
and eliminate defects.)
As soon as the engine is started, immediately release the key.
Warm up the engine.The temperature of coolant must be not less
than 60 °Ñ.
It is forbided to increase a crankshaft speed for warming-up
the engine.
Starting from Cold at Temperature Below - 20 °Ñ.
Before starting the engine, carry out the following operations:
1. Close the radiator shutter and mount the radiator shell
warmth-keeping cover.
2. Using the starting handle, turn over the engine crankshaft
for 3-5 times.
3. Pull the choke control knob all the way out (preliminary,
the throttle valve control pedal should be pressed).
Carry out the subsequent operations in the order specified for
starting the engine at temperatures of 0 °Ñ and above.
After the engine is warmed up, push the choke control knob
all the way in.
Starting from Cold at Temperature Below - 20 °Ñ.
Before starting the engine at a low temperature, warm it up
(by means of hot water, steam or air etc.).
Before starting the engine, it is recommended to warm up the
transistor commutator, for this purpose switch on the ignition,
and start the engine in 3 minutes.
Carry out the subsequent operations in the order specified for
starting the engine at temeratures of 0 °Ñ to -20 °Ñ.
Starting from Hot.
When starting from hot, do not push the choke valve control
knob in, and the throttle valve control pedal is not be sharply