UAZ UAZ-31512, Инструкция по эксплуатации

Страница: 97 / 113

97
Fig. 87. Scheme of automobile
loading (unloading)
Before loading check the driver's kit, accessories and spare
parts in accordance with the complete list.
The loading and unloading should be carried out by a crane
with special grips in accordance with the scheme in Fig. 87.
On all transports the automobiles should be located so that
the distance between the automobiles (extrem points) on the
radiator side would be equal to 50-100 mm, and on the other
sides - not less than 100 mm.
When moving, the parking brake of the automobile should
be on, the engine - shut down, the gearbox lever should be in
the position of the first gear, the fluid (water) should be poured
out from the cooling system and the sighboard "Water is poured
out" should be hanged, the storage battery should be cut off with
the ground switch.
To protect the automobile from axial and side shiftings attach
it with four tension wires of steel wire (dia. 6 mm) with double
thread each, and also with wooden wedges 300x160x80 nailed
to the floor under wheels. Attach the tension wires to the towing
hooks on th frame ahead, and to the towing gear-in rear part of
the automobile. After attaching seal the automobile.
Before moving by air, fill the fuel tanks with fuel, but not
more than 75% of its capacity.
The automobile should be get into an airplane with the gear
box shifted in the first gear and with the transfer box shifted to
the low range or by moving backwards (depending on the
loading or unloading conditions).