Tvone C3-440, Руководство пользователя

Страница: 31 / 225

tvOne Introduction 23
Input and Output Naming Convention
The CORIOmatrix protocol uses a fixed naming convention. You can create
aliases within the control software but it is helpful to understand the default
naming convention.
The naming is defined by the position of modules within the CORIOmatrix product.
The figure below shows the unit as viewed from the rear. Each location in which a
module can be placed is called a slot and each slot is numbered from the top left,
going across then down.
The first slot is numbered 1; the last is 20. Slot 17 is a special slot holding the CPU card
and slots 18,19 and 20 only work with data, not video signals.
On a CORIOmatrix mini, slots are also numbered left-to-right, but there are a total of
six slots; slot six is already filled with DVI-I or DVI-U connectors (CORIOmatrix units
built after early 2015 have DVI-I; earlier models use DVI-U). The CPU card is to the
left of Slot 1.
The fixed label for slot 1 is Slots.slot1
The video modules have inputs and outputs. Most cards have two connectors per
slot or per module that slides into the slot.
Inputs are addressed by in1 and in2; outputs are addressed by out1 and out2. HD-
SDI input cards also have in3 and in4.
Like the slot numbering system, they are numbered from left to right when you
are facing the rear of the CORIOmax.
The fixed label for the left-most input on slot 1 is Slots.slot1.in1