TV One C2-7100, Руководство по эксплуатации

Страница: 78 / 150

71
The sub-network’s ‘sub-net mask’ then needs to be copied to the ‘IP sub’
menu item listed below.
For simple setups (where only a single sub-network is in use), there is no
need to change the IP gtwy (gateway) numbers.
This parameter has three possible states: On, Off and Auto. On and off
manually control the Ethernet capability of the unit. When in Auto mode, if a
valid Ethernet connection is present, remote control of the unit will
automatically default to Ethernet and control via RS-232 is disabled whilst that
connection is maintained.
Enter 4 numbers one by one to form the IP address you wish to assign to the
unit. The IP address is a series of four numbers between 0 and 255. Anything
above 255 is not a valid number in an IP address range. The unit will not allow
you to go above 255.
The IP address must be a unique address on your network, and also must be
within the sub-net of your network. If you are unsure about which IP address
to use or don’t have a unique IP address, ask your Network Administrator.
Adjust the last 2 numbers to set the sub-net address (also know as sub-net
mask) of your network. Again, if in doubt ask your Network Administrator.
Enter your network’s gateway IP address into this menu item. Again, if in
doubt ask your Network Administrator. In general, the gateway only needs
setting if the unit is being controlled from a different network (e.g. via the
internet).
Enter the IP port number you wish the unit to communicate on. Keep a note of
this as it will be needed when using other devices to communicate with the
unit e.g. CC-300.
Adjust ethernet
IP add. [ 10] 1 2 123
Adjust ethernet
IP sub. 255.255. [255.000]
Adjust ethernet
IP gtwy. [ 10] 1 2 123
Adjust ethernet
IP port [10001]
1A Adjust Ethernet
Set new IP data & reboot
Adjust ethernet
IP enabled [Auto]