Page 42 of 77
2.
Verify that you chose the required cycle.
3.
If the autoclave is equipped with a printer verify that a paper roll is
inserted in the printer. If not - insert as per para. 5.2.
11.4.1
Closing the door
1.
Hold the opening handle in open position, while pushing the
door until it comes to closed position, then release the handle.
2.
The open door symbol
is replaced by the message
"System Ready".
11.4.2
Starting cycle
1.
Start the cycle by pressing the START/STOP key.
The autoclave starts performing sequence of operations. The
actual measured values of pressure and temperature are
displayed continuously and printed every minute at
STE
stage,
and every 5 minutes at the other stages. The phase in progress
is displayed at the right
side
of
the
upper
line
as
WATER
,
HEAT
,
STER
., and
EXH
.
If the operator presses the
START
key and the door is not
completely closed, the process will not start and the
DOOR
indicator will flash twice then turn off and the buzzer will sound
four times.
CAUTION
Do not touch the strainer’s cover, mounted on the exhaust
line, during and short after operation.
Touching the hot strainer’s cover may cause severe
injuries.
Содержание 2840 EL-D
