2.10
<2>
The next step is to secure the extruder wiring harness to the top panel using a zip tie.
Move the extruder to the
front left position
and then slip a zip tie in the right hole and
secure up the wiring harness (
pictures
2.10c
and
2.10d
). This creates enough slack in
the wiring harness to move around as well as keeping clear of moving parts.
Picture 2.10c
Picture 2.10d
We will now install the filament spool support. The two upright supports are bolted to the
side panels with 4 SCW0188 screws (
picture 2.10e
). The two supports have an inside and
an outside if you look at where the two tubes come together and the plastic block there is
a slot for the axle to the seat, there is a flat side that stops the axle from moving side to
side. This flat side goes toward the outside (
picture 2.10f
). Tighten the two bolts using a
7mm wrench (
pictures 2.10g
and
2.10h
).
Picture 2.10e
Picture 2.10f
Zip tie here
41
Содержание PRM0282
Страница 1: ...User Guide 3D Printer 1...
Страница 60: ...PRM0282...
