2.8
<1>
Feed the loom in the bottom slot and guide it around the back right rod and tuck it under
the lower plate support (
picture 2.8i
) and bring it out the front.
Picture 2.8i
Now slide the print head to the back and locate the sensor wire on the left side (
picture
2.8j
). Run the wires toward the front and down zip tying it to the left panel where noted in
the picture (
picture 2.8k
).
Picture 2.8j
Picture 2.8k
Let’s switch to the right side, we need to gather the side motor (X-axis) and the right sensor
(
picture 2.8l
) and bring them down and zip tie them to the lower motor housing (
picture 2.8m
).
Then, with the print head all the way to the back bring the wires to the front and down zip
tie-in where noted in the figure.
Picture 2.8l
Picture 2.8m
32
Содержание PRM0282
Страница 1: ...User Guide 3D Printer 1...
Страница 60: ...PRM0282...
