Turnigy PRM0282, Руководство пользователя

Страница: 16 / 60

2.2
<13>
Now that the first components are trammed we need to secure the torque coupling to
the stepper motor.
Loosen the coupling from the lead screw and slide it down so that there is an equal
distance top and bottom from the lead screw and motor (shown below).
Then tighten both ends of coupling
1
Equal
Equal
2
2
Loosen Tighten
Tighten
3
3
Great job up to this step!
2.5mm hex
driver
Next we are going to install the side panels. The side panels have a few things we need to
pay special attention to.
Both sides have the forward print platform vertical rods. This requires us to install the side
panel by sliding them down from the top.
The left panel (DSA3302-U06) has the A/C receptacle that needs to be attached from the
inside using some screws and nuts before we slide it down making installation easy to get to.
Place Side panel close to printer bottom
so we do not pull or damage the AC wires
from the power supply
Box-G Find the following accessories from:
Pre-assembled Rod
(for Left and Right panels)
MDT0139
Nut
x2
SCW0157
(TM4x12)
x2
(TB3x12)
x2
2.0mm hex
driver
DSA3302-U06
from Box-F
Left panel
Pre-assembled Rod
(for Left and Right panels)
x1
A/C receptacle from
bottom panel
SCW0153
x2
16
2.3
<1>