Turnigy PRM0282, Руководство пользователя

Страница: 17 / 60

2.3
<2>
A/C receptacle from
Bottom panel
DSA3302-U01
Put the two screws (SCW0157) in from the outside of Left panel (DSA3302-U06) and then
slip the power receptacle over the exposed screws from the inside and install the nuts
(MDT0139) as shown below.
NOTE: the switch goes toward the front of the printer and the tapered side toward the
rear matching the panel cutout.
2.5mm hex
driver
7mm
wrench
(Inner side)
Assembled (seen from outer side)
2.3
<3>
With the power switch / receptacle installed in the panel, it’s time to install the left panel by
carefully sliding the vertical rod down the front print platform bearing (pictured below right)
and making sure the rod aligns with its lower mount (pictured below right bottom).
2.3
<1>
2.3
<2>
2.2
<13>
17