Turf Equipment Z-SPRAY, Руководство оператора

Страница: 16 / 64

Operation
Choke Control
Located in the center of the control console (see
Figure 5).
The choke is used to aid in starting a cold engine.
Pulling up on the choke will put the choke in the
“ON” position and pushing down on the choke will
put the choke in the “OFF” position. Do Not run a
warm engine with the choke in the “ON” position.
g313931
Figure 5
1. LH Motion control lever 6. Hour Meter
2. Front reference/Speed
control bar 7. RH Motion control lever
3. Throttle 8. Operator Presence
Control (OPC) lanyard
4. Choke
9. Parking brake
5. Ignition switch
Throttle Control
Located in the center of the control console (see
Figure 5).
The throttle is used to control engine speed. Moving
the throttle lever forward will increase engine speed
and moving the throttle lever to the rear will decrease
engine speed. Moving the throttle forward into the
detent is full throttle.
Park Brake Lever
Located on the left side of the control tower (see
Figure 5).
The brake lever engages a parking brake on to the
drive tires.
To engage, pull the lever up and forward.
To disengage the brake, push the lever back and
down.
When parking on a steep slope, the wheels must be
chocked or blocked in addition to the brake being
engaged. The machine must be tied down and brake
engaged when transporting.
Ignition Switch
Located on the right side of the control console.
The ignition switch is used to start and stop the
engine. The switch has three positions “OFF”, “ON”
and “START”. Insert key into switch and rotate
clockwise to the “ON” position. Rotate clockwise to
the next position to engage the starter (key must be
held against spring pressure in this position). Allow
the key to return to the “ON” position immediately
after the engine starts.
Operator Presence Control (OPC)
Lanyard
Located below the ignition switch on the control
console.
It is recommended to attach the Operator Presence
Control (OPC) lanyard to the operator. If the lanyard
claw disconnects from the stem, the engine will
shutdown.
To make sure the lanyard is attached properly to the
machine, pull up on the knob and then push the
lanyard claw firmly onto the stem.
g314523
Figure 6
1. Pull up 3. Lanyard claw
2. Stem
Hour Meter
Located to the right of the throttle.
16