Maintenance
2.
Check tire pressure in drive tires.
3.
Inflate all tires to 18 psi (124 kPa).
Check Spreader System
Service Interval: Every 50 hours
Spray the hopper cables, accuway cable, and the
deflector shield cable with silicone spray if needed.
Clean the bottom of the hopper with a wire brush
and clean off any fertilizer if needed.
Change out the hopper bottom bushing or the
impeller if needed.
Check Sprayer System
Service Interval: Every 50 hours
1.
Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2.
Check all hoses, nozzles, and fittings for leaks.
3.
Check nozzle strainers and in-line strainers.
4.
Replace as needed.
Check In-line Filter
Service Interval: As required
Periodically check the in-line filter for any debris in
the screen. If debris is present, this can create erratic
pressure spikes and/or not allow the proper flow
through system. After clearing any debris, ensure that
gasket remains intact and tighten in-line filter cap (if
not installed properly, this will allow air to get in the
system and system will lose or not create pressure).
g271206
Figure 38
1.
Cap
3.
Gasket
2.
Filter
4.
In-line filter housing
Check Fuel Filter and Tank
Service Interval: Before each use or daily
1.
Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2.
Check the fuel filter and tank for leaks. See
Engine Owner's Manual.
50
