Trotec TAC XT 18, Оригинальное руководство пользователя

Страница: 8 / 59

8 EN vertical heater TAC XT 18 / TAC XT 27
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
To make the device easier to transport, it is fitted with a
transport handle and two wheels.
Wear foot protection
Wear suitable foot protection transporting the device.
Risk of injury caused by the foot when setting down the
device.
Before transporting the device, observe the following:
• Switch the device off.
• Hold onto the mains plug while pulling the power cable out
of the mains socket.
• Do not use the power cable to drag the device.
• Only wheel the device on a level and smooth surface.
• Remove all packing materials which serve to protect the
device during transport.
• Should the device be damaged, please contact the
responsible dealer or manufacturer, where the purchase
was made.
• Carefully tilt the device. Do not incline more than
necessary.
• Carefully set the device back down again.
• The device may only be lifted at the points provided with
lifting gear intended for handling. The carrying capacity of
the lifting gear must be suitable for the weight of the
device (see technical data).
After transporting the device, proceed as follows:
• Set up the device in an upright position after transport.
Storage
When the device is not being used, observe the following
storage conditions:
• Store the device in a dry location and protected from frost
and heat.
• If required, use a cover to protect the device from invasive
dust.
• Before restarting the device, check the condition of the
power cable. If there are doubts as to the sound condition,
contact the customer service.
• Have the device checked once a year by an electrically
skilled person at any rate.
Assembly and installation
Scope of delivery
• 1 x Device
• 1 x DualDecon blowing-out tower
• 1 x Prefilter G4
• 1 x Manual
Assembly
Installation of the blowing-out tower and insertion of the
HEPA filter (optional)
1. Using a screwdriver, remove the protective caps of
the 4 screws from the top of the device.
2. Remove all 4 screws.
3. Take off the blowing-out tower (
1 ) from the device.
1
4. Insert a HEPA filter ( 10 ) for the air purification mode.
ð
Pest control requires a maximum air flow rate.
Therefore we recommend not using a HEPA filter for this
application.
ð
The HEPA filter (optional) may only be used with the
upper filter insert (
11 ).
10
11
5. Place the desired blowing-out tower ( 1 ) on the device.