Trotec TAC XT 18, Оригинальное руководство пользователя

Страница: 12 / 59

12 EN vertical heater TAC XT 18 / TAC XT 27
Switching the device on
1. Once you have completely installed the device as
described in the Start-up chapter, you can switch it on.
2. Turn the main switch ( 15 ) to 1 .
ð
The device is initialized.
ð
Please wait will be indicated on the display.
1234 123,4 123
123,4
please wait
?
14:29 TAC XT
ð
Once the device has been initialised, the display
switches to standby mode.
3. Briefly touch the centre of the display.
ð
The main menu appears on the display.
Main menu
Off On
Setpoints
Configuration Back
4. If required, select the device function and carry out the
settings of the setpoints (see the following sections in the
“Operation” chapter).
5. Start the device or function by pressing the On button.
Enter the pass code
You might be requested to enter your pass code at initial start-
up.
The following screen will appear:
Factory settings
Enter pass code
reset
Factory settings
Activation Back
Please proceed as follows to enter the pass code:
1. Press the Enter pass code button.
2. Enter the pass code.
3. Press the Accept button to confirm the entry.
ð
If the pass code is incorrect Code invalid is displayed. If
the entry is correct, it is saved.
Back
12345
Enter pass code
Confirm
Code invalid
4. Press the Back button to exit the pass code entry area.
Note
If you forget the PIN, you will not be able to unlock the
display. In this case you can request an emergency
unlock code via the Trotec GmbH service hotline
on +49 02452 962-730. The service hotline is
available Monday to Thursday from 8 am to 5:30 pm
and Friday until 5 pm. You need the date and time
indicated on the display. You can view the information
by pressing the time button.
Language setting
1. Press the Configuration button in the main menu.
ð
Buttons for further settings will be indicated on the
display.
System
Configuration
Function selection
System settings
Back
2. Press the System settings button.
ð
The following screen is shown:
Back
System Vers. : 2.03.01
Factory settings
Language setting
Clock setting
Touch/Display
3. Press the Language selection button to select a language.
4. Use the arrow buttons to select the desired language.
5. Confirm the language selection by pressing the
Confirm
button.
6. Press the Back button to exit the language settings.