Trotec TAC XT 18, Оригинальное руководство пользователя

Страница: 21 / 59

EN 21 vertical heater TAC XT 18 / TAC XT 27
Activities required before starting maintenance
Warning of electrical voltage
Do not touch the mains plug with wet or damp hands.
• Switch the device off.
• Hold onto the mains plug while pulling the power cable out
of the mains socket.
Warning of electrical voltage
Maintenance tasks and repair work may only be
performed by qualified electricians or Trotec.
Warning
Observe local provisions and regulations on hygiene
when cleaning. Protect yourself during cleaning and
maintenance work with suitable protective equipment
(e.g. protective mask, protective glasses and gloves).
Note
Prior to cleaning the interior, protect the fan and further
electrical components from water ingress with
appropriate means.
Cleaning the housing
Clean the housing with a soft, damp and lint-free cloth. Make
sure that no moisture enters the housing. Protect electrical
components from moisture. Do not use any aggressive cleaning
agents such as cleaning sprays, solvents, alcohol-based or
abrasive cleaners to dampen the cloth.
Wipe the housing dry after cleaning.
Visual inspection of the inside of the device for dirt
1. Remove the air filter.
2. Use a torch to illuminate the openings of the device.
3. Check the inside of the device for dirt.
4. If you see a thick layer of dust, have the inside of the
device cleaned by a specialist company or by Trotec.
5. Put the air filter back in.
Changing the filter
The filter change intervals depend on the degree of air pollution
and the filter quality. Dirty filters impair the performance ability
of the device. When a certain degree of pollution of the filter is
reached, a warning is shown on the display. In this case,
reinsert a new filter.
Info
If a warning to change the HEPA filter is displayed, first
check whether the prefilter fleece is dirty. Replace the
HEPA filter with a new filter if you have replaced or
cleaned the prefilter fleece and the warning message
is still indicated.
Please proceed as follows to change the HEPA filter:
1. Using a screwdriver, remove the protective caps of
the 4 screws from the top of the device.
2. Remove all 4 screws.
1
3. Take off the blowing-out tower ( 1 ) from the device and
carefully put it aside.