SpeedMarker 300 /
ProMarker 300
Ausgabe 1.0
Technische Änderungen vorbehalten.
TROTEC Produktions- u. Vertriebs GmbH
Linzer Straße 156, A
– 4600 Wels
Seite
7
von 42
Intended Use
The Trotec SpeedMarker 300 / ProMarker 300 is intended exclusively for laser marking using the supplied marking
software.
Materials such as metal, anodized aluminum, and several plastics can be processed on the laser.
The following points should also be observed as part of the intended use:
only mark approved materials using suitable parameters
The working process mustt only be performed with a perfectly adjusted machine (see also
Section 9 Commissioning)
The system must only be operated, maintained and repaired, by personnel that are familiar
with the designated field of use and the dangers of the machine!
Non-observance of the instructions for operation, maintenance and repair described in this
Operation Manual excludes any liability of the manufacturer if a defect occurs.
Use of the system in other areas is against the designated use. The manufacturer does not
admit liability for damage to personal and/or equipment resulting from such use
The use of a suitable extraction system to remove fumes, dust or other reaction products is
absolutely necessary.
observe effective safety regulations and the procedures described in this Operation manual
caution when processing conductive materials (carbon fibers,)! Conductive dust or particles
in the ambient air might damage electrical components and lead to short circuits. Bear in mind
that those defects are NOT warranted.
If the intention is to use the system for other applications, Trotec Produktions und Vertriebs Ges.m.b.H. should be
informed in advance
Disposal remarks
Do not dispose the machine with domestic waste!
Electronic devices have to be disposed according to the regional directives on electronic and
electric waste disposal. In case of further questions, please ask your supplier. He might take care
of proper disposal.
