LASER ENGRAVING&CUTTING CONTROLLER AWC608
、
31
(1) Cycle diameter less than 5mm, processing speed to be 10mm/s
(2) Cycle diameter between 5~10mm, processing speed to be 20mm/s
(3) Cycle diameter more than 10mm, there is no processing speed limit, and equals to speed set in
the parameter
[Engrave Reverse offset]: When applying two-way engraving image, it may cause the edges of the
scanned image not to be smooth due to mechanical return gap. So this is corrected
by increasing reverse offset. Specific speed has the specific reverse clearance.
Generally, the greater the speed is, the bigger the reverse clearance is. Reverse gap
value could be positive or negative.
Current setting of [Engrave Reverse offset]
means:
(1) When speed is 200 mm/s, reverse offset is 0.30mm;If speed is smaller than 200mm/s,reverse
offset is in proportion to speed. Namely, when speed is 100mm/s, reverse offset will be 0.30*(100/200)
=0.15mm
。
(2) When speed is 300 mm/s, reverse offset is 0.50mm; If speed is between 200~300mm/s,
reverse offset is in proportion to speed. Namely, when speed is 250mm/s, reverse offset will be
0.30+(300-250)/(300-200)×(0.5-0.3)=0.40mm
。
(3) When speed is bigger than 300 mm/s, reverse offset equals the value when speed is
300mm/s( 0.50mm)
3.4 Open & Save Files
The files used by the software is pwj5 format, the pwj5 file save the image information, all layers’
processing parameter, and all image elements processing sequence. So need save all imported image
data as pwj5 format, so make it easier for the image processing afterwards.
3.4.1 Open File
(1)Click [Open] option in [File] menu, or click
icon, and open dialog box as below:
(2) Select the file needed (etc. 111.pwj5), then click [Open].
