LASER ENGRAVING&CUTTING CONTROLLER AWC608
、
49
Select “cut” or “cut after engraving” in
【
Work mode
】
, cut parameter is valid as below image:
【
Speed
】：
Working speed of laser head during cutting.
【
Working power
】：
Maximum power; To adjust the maximum value of laser power during
processing layer
（
Unit:%
）
. It’s the power of laser 1 of AWC608 control
panel.
【
Corner power
】：
Minimum power; the lowest power value during variable motion. It‘s the
power of Laser1 of AWC608 control panel.
（
Make sure laser intensity invariable during process by adjusting above two parameters
）
.
【
Overlap length
】：
Due to tolerance with machine, probably it will happen that closed
image can’t be cut off. So this parameter can help to solve this problem.
But this parameter should not be too large. Suggest adjusting precision of
machine to solve this problem.
：
Set cut advance parameter. Click this button, dialog box displayed as below:
【
Working power2
】：
To adjust the maximum value of laser power during processing layer
（
Unit:%
）
. It’s the power of laser 2 of AWC608 control panel.
【
Corner power2
】：
the lowest power value during variable motion. It‘s the power of
Laser2 of AWC608 control panel.
【
Open delay
】：
set the delay time before opening laser.
。
【
Close delay
】：
set the delay time after closing laser.
◆
Engraving Parameter
Select “engrave” or “engrave after cutting” in
【
Work mode
】，
engrave parameter is valid as below
image:
