LASER ENGRAVING&CUTTING CONTROLLER AWC608
、
26
RAM, and give control panel correct settings. Click [Save]
If not click [Save] after parameter settings, the settings will not be effective.
3.3.3 User Parameter
View
3-3-3
3.3.3.1Wrok Control Parameters (Refer to View 3-3-3)
[Space Speed]: During work, the max operation speed of laser head when laser off.
The value range of this parameter is limited to Axis [Max Speed] of manufacturer
parameter, shall not be bigger than max speed of the manufacture parameter.
[Start Speed]: Start speed during processing, the value range of this parameter is limited to Axis
[Start Speed] of manufacturer parameter, shall not be bigger than max speed of the manufacture
parameter.
[Speed Factor]: Factor determining the turn speed in work. The bigger the factor is, the faster the
work-speed is. Then bigger dither accordingly. Value range between 0~5, normally set at 2.
[Space Jerk]: Speed of acceleration during space process. The bigger the value is, the faster the
space is, then bigger dither accordingly. Value range is between 10000~60000 normally.
[Cut Jerk]: Speed of acceleration during cutting process. The bigger the value is, the faster the
cutting is, then bigger dither accordingly. Value range is between 5000~50000 normally.
[Min Acc.]: Min acceleration of axes movement during processing.
[Cut Acc.]: Max acceleration of laser head movement during processing when laser on.
Normally set below 1500.
[Space Acc.]: Max acceleration of laser head movement during processing when laser off.
Normally set below 2000.
[Engrave ACC.]: Max acceleration of laser head movement during processing when engraving.
Normally set above 8000.Too small setting will lead to too long distance before initial
speed accelerates to engraving speed, causing that a failed engraving because of
out-of-range.
