Triron KAHO, Инструкция по установке и эксплуатации

Страница: 13 / 20

Manual mixer shower
11
FITTING THE COVER PLATE
Fit the cover plate over the valve and slide tight
to the wall. Make sure the seal in the opening
stays in place as it slides over the valve body.
A smear of liquid soap on the seal will ease this
procedure.
FITTING THE CONTROL LEVER
Makes sure the cover plate is in place before
fitting the control lever.
• Push the control lever onto the valve. Using
an Allen key, secure the lever to the valve by
tightening the screw on the underside of the
lever and fit the trim
(fig.15) .
BULKHEAD ASSEMBLY
• Screw the bulkhead elbow to the bulkhead
body with the three screws supplied.
• Screw the completed assembly onto the
threaded connector temporarily to mark the
position of the two fixing holes
(fig.16) for
securing the bulkhead to the wall.
Note: If screw thread protrudes too far out of
the wall, it can be be cut to the correct length
using a hacksaw.
• Unscrew and remove the bulkhead assembly.
Check the location of the pipe in the wall
before drilling.
• Drill and plug the holes. (Use an appropriate
masonry drill, but if the wall is plasterboard or
soft building block, you must use special wall
plugs and a suitable drill bit).
If fitting to a hollow wall structure, it may be
preferable to secure the bulkhead by applying a
bead of silicon seal to the back of the bulkhead.
• Apply PTFE tape to the threaded connector.
• Screw the bulkhead assembly onto the
threaded connector until tight to the wall
and the two fixing holes are aligned. Secure
to the wall with the two screws supplied
(fig.17) .
• Finish by clipping the cover onto the
bulkhead, making sure the protruding legs
locate in the bulkhead body.
Fig.16
Fig.17
Grub screw
in recess
Fig.15