3
4
6
7
8
5
1
2
6
Introduction
(continued)
Components
(continued)
Rear View
No . Component
Description
1
Power Sockets (C14)
The two C14 power sockets are located here. Connect the included power cords (C13 to 5-15P) from here to an
appropriate power source.
Note: To help protect your system from sudden, transient increases and decreases
in electrical power, it is recommended that you plug your devices into a Tripp Lite surge protector, line
conditioner or uninterruptible power supply (UPS).
2
Power Switches
The On/Off switches for the two power supplies are here.
3
Secondary LAN Port
(LAN 2)
The cable that connects the KVM switch to the backup network plugs in here.
4
Primary LAN Port
(LAN 1)
The cable that connects the KVM switch to the primary network plugs in here.
5
Grounding Terminal
Connect the included grounding wire to this terminal to ground the KVM switch.
6
Modem Port
An optional dial-in connection is available for use in the event the KVM switch is not available over the Primary
or Secondary networks.
7
Local Console Ports
This area features VGA and DVI ports for the connection of either a VGA or DVI monitor, as well as two USB
ports for the connection of a keyboard and mouse.
Note: The B064-008-01-IPG and B064-016-01-IPG will not
feature a DVI-D port but instead two PS/2 ports for connection of mouse and keyboard.
8
Server Ports
Cat5e/6 cable connects between these ports and the SIUs to connect computer/servers to the KVM switch.
Note: The figure above shows the rear panel of a B064-032-04-IPG or B064-032-02-IPG. The B064-016-04-IPG and B064-016-02-IPG differ
in that it only has a single block of 16 KVM ports.
