Trinity MPS 350, Инструкция по эксплуатации и сборке товара

Страница: 6 / 62

www.highwayguardrail.com
Revised: April 18, 2008 5
!
WARNING:
The MPS 350 must be lowered completely until the Frame Assembly’s weight
rest on the Support Chains. Failure to follow this warning could result in serious injury or death
to the operator and/or bystanders.
!
WARNING:
Keep clear of the MPS 350 while in operation. Do not sit or stand near, under or
behind MPS 350 while lowering or raising the MPS 350. Failure to follow this warning could
result in serious injury or death to the operator and/or bystanders.
!
WARNING:
Ensure that all fasteners are secure. Failure to follow this warning could result in
serious injury or death to the operator and/or bystanders.
!
WARNING:
Ensure that the winch strap is tight and without any slack before releasing the
Latch Bar Assembly. NEVER RELEASE THE LATCH BAR ASSEMBLY IF THE WINCH
STRAP IS SLACK . Failure to follow this warning could result in serious injury or death to the
operator and/or bystanders.
!
WARNING:
Ensure that no one is near, under or behind the MPS 350 when in operation.
Failure to follow this warning could result in serious injury or death to the operator and/or
bystanders.
!
WARNING:
Do not operate the MPS 350 while wearing loose fitting clothing, which may
become tangled in the MPS 350 during operation. Failure to follow this warning could result in
serious injury or death to the operator and/or bystanders.
!
WARNING:
Do not use hands or feet to lift or support the MPS 350. Always use Jack
supports provided. Always keep feet clear of frame when in operation and during maintenance
activities. Failure to follow this warning could result in serious injury or death to the operator
and/or bystanders.
!
CAUTION:
Failure to ensure proper function of the Limit Switch may result in failure of the
Winch.
!
CAUTION: I
nform the truck driver that the MPS 350 is going to be installed, repaired,
operated, or adjusted. Block the wheels. Remove the keys from the ignition of the truck and
place signs on the truck that it is being serviced – DO NOT START ENGINE.
!
CAUTION:
When traveling to and from a work zone, travel with the MPS 350 in the Up
(Traveling) Position.
!
CAUTION:
While traveling in a moving work zone, NEVER drive faster than 35 mph (55
km/hr) with MPS 350 in a Down (Operating) Position. Speeds slower than 35 mph (55 km/hr)
may be required if bouncing of the MPS 350 occurs.
!
CAUTION:
Prior to mounting the MPS 350, verify that the fuel tank(s) on the truck is more
than 10 feet 6 inches (3200 mm) from the rear of the truck. If the distance is less than 10 feet 6
inches (3200 mm) contact your Trinity Highway Products Representative about various
extensions.
MPS 350 Safety, Installation, Operation and Maintenance Manual