Trinity MPS 350, Инструкция по эксплуатации и сборке товара

Страница: 29 / 62

www.highwayguardrail.com
Revised: April 18, 2008 28
(Step 3 Continued)
!
WARNING:
The MPS 350 must be lowered completely until the Frame
Assembly’s weight rest on the Support Chains. Failure to follow this warning could
result in serious injury or death to the operator and/or bystanders.
!
CAUTION:
Do not leave the Winch Strap tight in the Down (Operating) Position,
while the MPS 350 is being used, the Winch and the attachment point to the Frame
Assembly could be damaged.
!
CAUTION:
The Winch Strap on the MPS 350 should ALWAYS go over the top of
the Winch Drum to ensure proper function of Winch system.
Figure 24.3 Always Locate Strap to Wrap Over Top of Winch Drum
NOTE: A Cab Operated Release System is available for the MPS 350. Contact your Trinity Highway
Products representative for more information.
OPERATING HEIGHT: The MPS 350 can be adjusted by raising the MPS 350 with the Winch and then
adjusting the Turnbuckle in each Chain Assembly. The MPS 350 should be adjusted for 12” –14” (305 mm
- 355 mm) of ground clearance under each rear corner. (See Figure 25.0 Below.)
Figure 25.0 MPS 350 Correct Mounting Height (See Appendix Drawing 959/SS-298)
The Winch Strap
must be wrapped
over the top of the
Winch Drum.
MPS 350 Safety, Installation, Operation and Maintenance Manual