Trinity MPS 350, Инструкция по эксплуатации и сборке товара

Страница: 20 / 62

www.highwayguardrail.com
Revised: April 18, 2008 19
8 Be sure to install the 3051B - 3/8” Flat Washers where 3217B - 3/8”x 1” Hex Bolts
and 3257B - 3/8” Whiz Nuts contact the plastic components (Plastic Nose, Plastic
Sideboard, and Plastic Bottom Sheet) as shown in Drawing 7487 in the Appendix.
9
Tighten all 3217B - 3/8”x 1” Hex Bolts and 3257B - 3/8” Whiz Nuts.
Figure 13.0 Plastic Sideboards and Plastic Nose Piece Installation
16 Raise the MPS 350 to the Up position until the Latch Bar Arms drop into place over the Frame
Crossmenber on the Frame Assembly. The Latch Bar Arms must connect and engage the
Frame Crossmember and allow the Limit Switch to shut-off the Winch. (See the following
section: Raising The MPS 350)
Figure 14.0 MPS 350 in Up (Traveling) Position with Latch Bar Arms in Locked Position
!
WARNING:
Keep clear of the MPS 350 while in operation. Do not sit or stand
near, under or behind MPS 350 while lowering or raising the MPS 350. Failure to
follow this warning could result in serious injury or death to the operator and/or
bystanders.
Plastic Sideboards and Plastic Nose Piece
MPS-350 Frame
Assembly in Up
(Traveling) Position
with Latch Bar Arms
Locked in Place
MPS 350 Safety, Installation, Operation and Maintenance Manual