Trinity MPS 350, Инструкция по эксплуатации и сборке товара

Страница: 33 / 62

www.highwayguardrail.com
Revised: April 18, 2008 32
USING THE JACKS TO REMOVE THE MPS 350 FROM THE TRUCK:
The MPS 350 is supplied with three screw-type Jacks that can be used to maneuver the unattached MPS
350 away from the truck.
!
DANGER:
Do not operate the MPS 350 near overhead power lines. If the MPS 350 comes
into contact or close proximity with a power line or there is arcing, STAY in the truck cab. Keep
away from any metal parts on the MPS 350. Do not let anyone get close to the truck. Do not
attempt to jump from the truck. The Power Company must disconnect the power before you
can leave the cab.
Know the overhead clearance of overhead obstructions. NEVER drive the MPS 350 under any
overhead obstruction without knowing the clearance height. Failure to follow this warning
could cause damage to the MPS 350 and may result in serious personal injury or death.
!
WARNING:
Ensure that no one is near, under or behind the MPS 350. Failure to follow this
warning could result in serious injury or death to the operator and/or bystanders.
!
CAUTION:
Do not use hands or feet to lift or support the MPS 350. Always use Jack
supports provided. Always keep feet clear of frame when in operation and during maintenance
activities.
Step Actions
1 Confirm the truck is on a flat level ground.
2
Inform the truck driver that the MPS 350 is going to be installed, repaired, operated, or adjusted.
Block the wheels to ensure that the truck does not move, and do not start the truck.
Remove the keys from the ignition of the truck. Place signs on the truck that it is being serviced
– DO NOT START ENGINE.
3
Ensure the MPS 350 is in the Down position. There are three critical mounting locations where
the Jacks must be attached. (See Figure 28.0 and Figure 28.1 Below) Align each Jack even
with the mounting locations.
Figure 28.0 Side View - MPS 350 Jack Mounting Plates – Bracket Assembly Location
Figure 28.1 Rear View - MPS 350 Jack Mounting Plates – Frame Assembly Location
MPS-350 Jack
Mounting Plates
(one on either side
of MPS-350 Bracket
Assembly
MPS 350 Jack
Mounting Plates on
Impact Fence of the
MPS-350 Frame
Assembly
MPS 350 Safety, Installation, Operation and Maintenance Manual