Trinity MPS 350, Инструкция по эксплуатации и сборке товара

Страница: 16 / 62

www.highwayguardrail.com
Revised: April 18, 2008 15
6 Confirm the truck is on a flat level ground.
7 Inform the truck driver that the MPS 350 is going to be installed, repaired, operated, or adjusted.
Block the wheels to ensure that the truck does not move, and do not start the truck. (See Figure
7.0)
Remove the keys from the ignition of the truck. Place signs on the truck that it is being serviced
– DO NOT START ENGINE.
8 Add load to the truck. The truck must be loaded to the correct weight before the MPS 350 is
installed. The minimum loaded weight is 15,000 pounds (6,815 kg). This could be different for
local regulations. Consult your local governing specifications.
Figure 7.0 Add Load to Truck to Achieve Correct Weight
9 Move the MPS 350 into position at the back of the truck. Use the Jacks to set the correct
installed height at 36 inches (915 mm) to the center of the Pivot Bolt.
36 inches , plus ½” minus 0 (915 mm plus 12 mm minus 0 mm), (minimum height of 36” (915m)
and maximum height of 36-1/2” (927mm)) must be maintained to allow correct operation of the
MPS 350 during a crash.
Figure 8.0 Position MPS 350 for Attachment to Truck
36 in
915
mm
Pivot Bolt
MPS 350 Safety, Installation, Operation and Maintenance Manual