Trillium Roto-Jet R11, Руководство по разборке и сборке

Страница: 22 / 35

R11 2x2 19
2.7.6.7. Heat the inner race of the radial bearing (13) to 160°-185° F (71°-85°
C). Quickly slide the race over the driveshaft and against the spacer
set (23).
2.7.6.8. Install the outer race of the radial bearing (30).
NOTE: Check to see if oil slinger (20) will rotate freely after
bearings are installed. If oil slinger (20) rotates freely,
place the used bearing locknut (36) back onto the shaft.
Tighten bearing locknut using the bearing locknut torque
wrench adaptor until the oil slinger (15) is secured. Do
not exceed 400 ft. lbs. (542 N.M.).
Remove used bearing locknut (36) and discard.
2.7.6.9. Install new bearing locknut using the bearing nut adaptor, torque the
bearing to 130 ft. lbs. (176 M-N).
2.7.6.10. Position the excluder (85) against the driveshaft (5) shoulder.
2.7.6.11. Lubricate and install the rotor o-ring (12) into the groove on the rotor
(3) lip. Install the three rotor guide pins into the rotor.
2.7.6.12. Lubricate and install the rotor drain plugs (8) in the rotor cover (4).
Torque to 13 ft. lbs (18 N-M).
2.7.6.13. Being extremely careful not to damage the seal mating ring (78)
cavity, slide the pick-up tube (1) with the protective shield through
the opening in the rotor cover (4).
2.7.6.14. Holding the pick-up tube centered, align the rotor and rotor cover
match marks.
2.7.6.15. Guide the rotor cover (4) over the rotor guide pins and against the
rotor (3).
2.7.6.16. Match the twelve socket head capscrews (7) with their correct
positions in the rotor cover (4).
2.7.6.17. Seat the rotor cover (4) by evenly threading the socket head
capscrews (7). Replace the rotor guide pins with capscrews and
torque all to 47 ft. lbs. (6N-M).
2.7.6.18. Insure that the shims (38) are in place and flat against the bearing
cap (14).
2.7.6.19. Thread the rotor alignment rod into a threaded hole in the endplate
(15). Install the three eyebolts in the rotor cover (4) threaded holes
and adjust the eyebolt nuts until flush against the rotor cover.