Trillium Roto-Jet R11, Руководство по разборке и сборке

Страница: 17 / 35

R11 2x2 14
2.6.6.4. Using the seal installation tool, insert the seal (75) into the manifold
(36) cavity being careful not to damage the seal face. Install the
retaining ring (91) into the manifold groove.
2.6.6.5. Clean seal face and the seal mating ring face. Remove protective
shield.
2.6.6.6. Being extremely careful not to damage seal or seal mating ring,
install manifold (36). Slide pick-up tube guide through manifold.
Align manifold on manifold guide pins and slide into place on
pedestal while holding pick-up guide centered.
2.6.6.7. Remove the manifold guide pins and seat the manifold (36) into the
pedestal (17) by evenly torquing the ten hex head capscrews (94).
Torque the capscrews to 72 ft. lbs. (98 N-M).
2.6.6.8. Using the pick-up tube guide, align the manifold (36) keyway and the
pick-up tube (1) keyway. Pull the pick-up tube past the o-ring (49)
and against the manifold shoulder. Remove the pick-up tube guide.
2.6.6.9. Install the pick-up tube key (82) into the keyways. Using the lock nut
tool, thread lock nut (81) into pick-up tube. Torque lock nut to 217 ft.
lbs. (294 N-M).
NOTE: The 1/2 inch seal drain on the manifold should not be
plugged.
2.6.6.10. This completes the seal replacement procedure. The pump may be
put back into operation. Connect all piping and refer to Section 3.3
for start up procedures.
2.7. BEARING REPLACEMENT PROCEDURE:
WARNING: Before lifting the pump into the vertical position first remove the
lifting eye and install the swivel hoist. When tightening the swivel hoist ring, torque
to 100ft-lbs. Once the pump is re-assembled and in the horizontal position remove
the swivel hoist and re-install the lifting eye. Reference APPENDIX A Drawing.
2.7.1. Recommended Parts
Seal Kit
Bearing Kit
Rotor Cover Plugs
2.7.2. Recommended Special Tools
Lock Nut Tool Bearing Puller
Pick-Up Tube Guide Bearing Heater
Manifold Guide Pins Temperature Sticks
Manifold Puller Rotor Guide Pins
Seal Puller Bearing Nut Adapter
Seal Mating Ring Puller Seal Installation Tool
Eyebolt Rotor Alignment Rods