Trillium Roto-Jet R11, Руководство по разборке и сборке

Страница: 16 / 35

R11 2x2 13
2.6.5.2. Fully thread the pick-up tube guide into the pick-up tube (1). Tap
lightly on the pick-up tube guide until the pick-up tube clears the o-
ring (49).
2.6.5.3. Remove the ten hex head cap screws (94) which secure the
manifold (36) to the pedestal (17). Install two manifold guide pins
into two threaded holes in the pedestal (17) at the two o'clock and
ten o'clock positions.
2.6.5.4. Evenly thread two of the hex head cap screws (94) into the threaded
holes in the manifold (36) until the manifold moves free of the
pedestal (17). Carefully guide the manifold over the pick-up tube
until the pick-up tube guide is cleared. Place the manifold on a flat
surface with the seal (75) visible.
2.6.5.5. Remove the seal retaining ring (91) from the manifold. Grasping the
inside diameter of the seal spacer (13a) or the flush ring (13b), pull
to remove the seal (75) along with the seal spacer or the flush ring.
If unable to remove by hand, remove using the seal puller.
2.6.5.6. Remove the pick-up tube o-ring (49) and the seal o-ring (44).
2.6.5.7. Place a rubber protective shield between the pick-up tube (1) and
the seal mating ring (78). Remove the key (82) from the pick-up
tube.
2.6.5.8. Grasping the outside diameter of the seal mating ring (78), pull to
remove. If unable to remove by hand, install the seal mating ring
puller and evenly thread the two capscrews against the rotor cover
(4) until the seal mating ring is free of the rotor cover.
2.6.5.9. Remove the seal mating ring o-ring (69).
2.6.6. Assembly:
2.6.6.1. Lubricate and install the seal mating ring o-ring (69) in the rotor cover
(4). Lubricate the seal mating ring cavity with light oil.
2.6.6.2. Carefully guide the seal mating ring (78) over the pick-up tube guide
and the pick-up tube (1). Align the hole in the seal mating ring with
the driver pin (92) in the rotor cover (4). Slide the seal mating ring
into place until flush against the rotor cover.
2.6.6.3. Lubricate and install the pick-up tube o-ring (49) and the seal o-ring
(44) in the manifold (65). Lubricate the seal cavity in the manifold
with light oil. Place the seal spacer (13a) or the flush ring (13b) in
the manifold cavity.