Trillium Roto-Jet R11, Руководство по разборке и сборке

Страница: 24 / 35

R11 2x2 21
2.7.6.31. Remove the manifold puller. Using the pick-up tube guide, align the
manifold (36) keyway and the pick-up tube (1) keyway. Pull the pick-
up tube past the o-ring (49) and against the manifold shoulder.
Rotating the driveshaft by hand may make it easier to pull up the
pick-up base.
2.7.6.32. Remove the pick-up tube guide. Install the pick-up tube key (82) into
the keyways. Using the lock nut tool, thread lock nut (81) into pick-
up tube. Torque lock nut to 217 ft. lbs. (294 N-M).
2.7.6.33. Install oil drain plug (24).
2.7.6.34. Return pump to installation or position with shaft horizontal. Fill
pedestal with oil to the center of the oil sight gauge (68). Insure that
the oil rings (22) are in the correct position.
2.7.6.35. Insure that face of pedestal that mates to pedestal cover (18) is
clean. Place gasket on pedestal hole pattern. Fasten the pedestal
cover to the pedestal with the four hex head capscrews (57).
Torque to 4 ft. lbs. (5 N-M).
2.7.6.36. Using the wrench flats, install the breather filter (67). Install key (43)
and pump sheave. DO NOT hammer in place as the mechanical
seal may be damaged.
2.7.6.37. This completes the bearing replacement procedure. The pump may
now be put into operation.
2.8. STAINLESS STEEL MANIFOLD ASSEMBLY NOZZLE AND O-RING REPLACEMENT
The following procedure should be used when the o-ring must be changed to be
compatible with the fluid being pumped or the nozzle becomes damaged. This
assembly is not normally disassembled. The nozzle is an interference fit in the
manifold. Refer to figure 2.4.
2.8.1. Recommended Parts
Nozzle (95)
O-Ring, Nozzle (96)
2.8.2. Recommended Special Tools
Lock Nut Tool Manifold Puller
Pick-Up Tube Guide Seal Puller
Manifold Guide Pins
2.8.3. Preparations for Disassembly
2.8.3.1. Lock out and tag driver.
2.8.3.2. Blank off and drain the suction and discharge lines.