Traxon 160136, Руководство по установке

Страница: 21 / 64

21
Setup Manual - Video Micro Converter
Video settings
The video area is defined by its physical size (left, right, top and bottom) and the
video resolution (width and height). The physical size is the area where fixtures can
be mapped to the grabbed video. The combination of physical size and resolution
defines the video resolution inside a physical area. The input video is mapped to the
video area from the top-left corner of the video area. Therefore, to map an entire
input video, the video area resolution must be set to the same resolution of the in-
put. Which means: the fixtures must have the same number of pixels as the source
video. The maximum input resolution of the VMC is 1920 x 1080 pixels/1080p (Full
HD).
• Left click in the workspace area and the properties dialog will show size and
video area settings.
• Set video area width and height in pixels. Width and height must match VMC
video resolution. Open VMC configuration dialog and find resolution at the video
status information section if uncertain on resolution of video source.
• Set the physical LED matrix size for your video resolution or right click on any
fixture and select
Use Pitch for Video Area
from context menu. Typically,
the width and height in pixels multiplied by the LED fixtures pixel pitch.
• Define the section size. As a rule of thumb the section size should be equal or
greater than the video area.