Transtech Transputer, Руководство пользователя

Страница: 168 / 200

Network test utilities
160
Transputer Motherboard User Manual TMB M 711
For example, having installed a motherboard with four processors,
using the default jumper and switch settings, you can verify that the
board is working by typing:
c:\> check
Using 150 check 3.0.1
# Part rate Mb Bt [ Link0 Link1 Link2 Link3 ]
0 T805d-25 0.43 0 [ HOST ... 1:1 ... ]
1 T805d-25 1.75 1 [ ... 0:2 2:1 ... ]
2 T805d-30 1.77 1 [ ... 1:2 3:1 ... ]
3 T805d-25 1.79 1 [ ... 2:2 ... ... ]
The memory test is invoked as follows:
c:\> check | mtest
Using 150 check 3.0.1 | mtest 3.0.1
# Part rate Mb Bt [ Link0 Link1 Link2 Link3 ] RAM,cycle
0 T805d-25 0.43 0 [ HOST ... 1:1 ... ] 4K,1+4096K,3;
1 T805d-25 1.75 1 [ ... 0:2 2:1 ... ] 4K,1+4096K,3;
2 T805d-30 1.77 1 [ ... 1:2 3:1 ... ] 4K,1+4096K,3;
3 T805d-25 1.79 1 [ ... 2:2 ... ... ] 4K,1+4096K,3;
Interpretation of the output of check normally requires sketching a
diagram. The processors are numbered in the order that the worm
finds them, which is normally not the most intuitive numbering
scheme.
If
check
does not show the network you expect, refer to the trouble-
shooting guide in chapter 12.
11.5.1 Link Switch Configuration
The
check
utility can be used to set C004 link switches. This is
illustrated in the following example.
Consider a TMB17 with TRAMs fitted into sites 0, 1, 2 and 3. By
default, these are connected in a link 2 to link 1 pipeline as shown by
check
:
C:\TPS>set TRANSPUTER=tmb17
C:\TPS>check
Using tmb17 check 3.0.3