Transtech Transputer, Руководство пользователя

Страница: 58 / 200

Board Configuration Jumpers
50
Transputer Motherboard User Manual TMB M 711
By default, the reset line of the on-board transputer’s subsystem is
asserted whenever the on-board transputer is reset. However, the
TMB04 allows you to disable this behavior, so the TRAM slots are not
reset when the on-board transputer is reset.
5.3.3 Board IO Address
Configuration of the board IO base address is achieved via switch
SW1, as follows:
Jumper Position Description
LK12 Left Slots 0 to 3 are controlled from the
transputer’s subsystem port (default)
Right Slots 0 to 34 are controlled from the
same source as the transputer
Table 14: On-board transputer subsystem jumper
Switch Position Description
SW1.8 on transputer’s reset is copied to
subsystem (default)
off transputer’s reset is not copied to
subsystem
Table 15: On-board transputer subsystem reset handling
SW1.4 SW1.5 Description
off on Base address 150 hex (default)
on off Base address 200 hex
off off Base address 300 hex
on on Host link interface disabled
Table 16: Base address select switch