Safety Recommendations
The equipment described in this manual is the result of many
years of research and continuous development. To assist you
in obtaining the best use of it and maintaining it in perfect
operating condition over a long period of time, the
manufacturer has at your disposal a refrigeration and air
conditioning service school. The principal aim of this is to give
operators and technicians a better knowledge of the
equipment they are using, or that is under their charge.
Emphasis is particularly give to the importance of periodic
checks on the unit operating parameters as well as on
preventive maintenance. which reduces the cost of owning
the unit by avoiding serious and costly breakdown.
Training
To avoid accidents and damage, the following
recommendations should be observed during maintenance
and service visits:
1.
2.
Maintenance Contract
It is strongly recommended that you sign a maintenance
contract with your local Service Agency. This contract
provides regular maintenance of your installation by a
specialist in our equipment. Regular maintenance ensures
that any malfunction is detected and corrected in good time
and minimizes the possibility that serious damage will occur.
Finally, regular maintenance ensures the maximum operating
life of your equipment. We would remind you that failure to
respect these installation and maintenance instructions may
result in immediate cancellation of the warranty.
The manufacturer has a policy of continuous product
improvement, and reserves the right to alter any details of the
products at any time without notice.
This publication is a general guide to install, use and properly
maintain our products. The information given may be different
from the specification for a particular country or for a specific
order. ln this event. Please refer to your nearest office.
ln no event shall Trane be liable for any incidental or
consequential damages resulting from the use, misuse or
inability to use the product.
Disconnect the main supply before any servicing on the
unit.
Service work on the refrigeration system and the electrical
system should be carried out only by qualified and
experienced personnel.
55
Содержание CLCP Euro 25
