Trackmaster TMX58, Руководство пользователя

Страница: 45 / 66

TRACKMASTER Component Replacement
August 2013 TMX58 Owner’s Manual 8-3
NOTE:
A new belt will naturally stretch slightly within a short period of time after it is in
use. This stretch will cause the belt to hesitate briefly with each foot strike. This
condition is detrimental to the life of your new belt. Adjust tension immediately by
turning both tension bolts clockwise one-half turn until proper tension is attained. Do
not over tighten the running belt. If it appears that the belt is near the proper tension,
make one-quarter turn adjustment.
Roller Removal
NOTE:
Improper handling of the roller can damage the roller’s bearings. Do not drop or
impact the roller shaft. Always handle rollers horizontally.
This procedure requires the following tools:
• ½” socket wrench
• ¼” Allen wrench
• ¼” nut driver
Front Drive Roller
1. Elevate the treadmill to approximately 12%. Turn the master power switch to the
OFF position, and unplug it from its power outlet. Remove all fasteners securing
the front and rear sections of the hood and set it aside.
2. Turn both
5
/
16
” rear roller take-up bolts counterclockwise until there is no tension
on the running belt.
3. Remove the
5
/
16
” bolt that secures the front drive roller. Push the roller to the left
side of the treadmill, and then pull it out of the treadmill.
4. To install the roller, reverse the preceding steps. Ensure that the drive belt is
correctly placed on both sprockets.
5. Adjust the running belt tension and tracking.
Rear Roller (Driven Roller)
1. To remove the rear roller, 1
st
follow the steps for removing the front drive roller.
2. Remove the end caps.
3. Remove the two 5/16” rear roller take-up bolts that are used to adjust the running
belt.
4. Remove the rear roller by pulling it straight back past the side rails and then out
of the belt.
5. To install the new rear roller and reinstall the front drive roller, reverse the
preceding steps.