Figure 3.7.3: Set Torque
& Angle Function Graph
Figure 3.7.2: Set Just Move
Function Graph
12
Operating Manual
BlueTorq-Series
WWW.
TRACKWRENCH.COM
3.7.2.
Just
Move
Just Move allows the user to measure torque after rotation of a
pre-defined number of degrees. Degrees will count once load applied
is above 5% of the maximum tool span. Torque will be captured at the
angle defined here.
1. Press to scroll to Set mode.
2. Press to select Set mode.
3. Press to select Just Move.
4. Press to scroll to required preset number i.e. 1 to 99.
5. Press to confirm preset number selected.
6. Press to set just move preset angle
and to confirm.
3.7.3.
Torque & Angle
This mode allows the user to prepare Minimum & Maximum
acceptable limits for both torque and angle. The angle starts once the
reference torque has been reached.
1. Press to scroll to Set mode.
2. Press to select Set mode.
3. Press to select Torque & Angle.
4. Press to scroll to required preset number i.e. 1 to 99.
5. Press to confirm preset number selected.
6. Press to set reference torque value and to confirm.
Once this reference torque value is reached the Angle value
will set to zero degrees.
7. Press to set low torque value and to confirm.
8. Press to set high torque value and to confirm.
9. Press to set low angle value and to confirm.
10. Press to set high angle value and to confirm.
