Toshiba A03-009, Руководство по обслуживанию

Страница: 125 / 219

124
8-3. Slim duct
MMD-AP0074SPH
✽
, AP0094SPH
✽
, AP0124SPH
✽
, AP0154SPH
✽
, AP0184SPH
✽
No. Part name Procedure Remarks
REQUIREMENT
Be sure to put on gloves at working; otherwise an injury may be
caused by parts, etc.
• Before replacement of the parts, be sure to stop operation of the
air conditioner and turn off switch of the breaker.
1
1. Detachment
1) Push knobs (3 positions) of the air filter hooks toward the
arrow direction to remove the air filter.
2. Attachment
1) Insert the air filter surely into the hooking grooves (4
positions) at the opposite side of the hooks, and then fix it
to the original position.
NOTE
In case of sucking system from bottom side, installation direction
is determined. Install the air filter so that hooks are aligned at
discharge side.
2 Plate inlet-A
Plate inlet-B 1. Detachment
1) Take off fixing screws while holding the plate inlet-A with
hands to remove it. (Sucking system from rear side: Ø4 ×
10, 8 pcs)
(Sucking system from bottom side: Ø4 × 10, 11 pcs)
2) Take off fixing screws while holding the plate inlet-B with
hands to remove it. (Ø4 × 10, 6 pcs)
NOTE
Be careful that sheeting metal does not fall when removing the
plate inlet.
2. Attachment
1) Using the screws taken off in procedure 1. 2) of 2 , attach
the plate inlets in order of B
➝
A while holding them not to
fall down.
[In case of sucking system from rear side]
[In case of sucking system from bottom side]
Air filter
Push
Hook
Air filter
Hook
Push
[In case of sucking system from rear side]
[In case of sucking system from bottom side]
Plate inlet-A: 11 screws
Plate inlet-B: 6 screws
Plate inlet-B: 6 screws
Plate inlet-A: 8 screws