Toshiba A03-009, Руководство по обслуживанию

Страница: 139 / 219

138
8 Lower panel 1. Removing
1) Perform Step 1 of 1 and Step 1 of 7 .
2) For AP024 – AP048, remove the strengthening
metal fittings.
(Ø4 X 12, 1)
Remove the screw on the front, and thread it
through the square hole of the side. For AP015 –
AP018, there is no strengthening metal fitting.
3) Remove the screws from both sides.
(One side: Ø4 X 8, 3)
4) Remove the screw of the fan.
(Ø4 X 8, 3)
5) Slide the lower panel in the discharge direction to
remove it.
NOTE
Slide it horizontally from the drain pan of the discharge.
Applying excessive force may cause breakage.
6) When removing the sensor base, wrap vinyl tape
on the tip of a flat-head driver as shown in the
following picture, and then insert it into the groove
of the side below the
{ sign of the cover.
2. Attaching
1) Slide along the drain pan from the discharge to
attach it.
2) Insert the screws (strengthening metal fittings for
AP024 – AP048) removed in 1.
No. Component Procedure Remarks
Flat-head driver
(Wrap vinyl tape)
Insert into the groove
of the side below the
{
sign
Vinyl tape
Front: Screw end
Back: Insert into
square hole
Strengthening
metal fitting
Screw