Toshiba 65/5560, Руководство по обслуживанию

Страница: 57 / 75

4-1
65/5560 PERIODIC MAY.1997 © TOSHIBA CORP.
•
Inspection and Overhaul every 800,000 Coples
(1) Replace all the consumables.
(2) Check to see if there is any damage to parts of the driving section (gears, pulleys, timing belts, etc.).
Replace parts on principle if damaged.
(3) Check to see if there is any damage or peeling of adhered parts (tape, Mylar sheet, etc.).
Replace any affected parts.
(4) Check to see if all the switches and sensors operate properly. Replace them if they are not
operating properly.
(5) Clean the inside of the machine thoroughly.
4. PERIODIC MAINTENANCE
•
Inspection every 200,000 Copies
(1) Preparation
1) Ask the key operator about the present machine conditions and note them down.
2) Before starting the maintenance work, make and retain a few sample copies for later
comparison.
3) Turn off the power switch and disconnect the power cord plug.
(2) The periodic inspection should be conducted in accordance with the Periodic Inspection Check
List shown below. Perform the inspection by referring to the figures, as well as to the
explanations in the Service Manual when necessary.
(3) After the inspection has been completed, plug in the machine and turn the power switch on, and
confirm the general operation of the machine by making a few copies and comparing them to
those made previously.
Note: For inspection and maintenance of the PFP, remove the PFP upper aligning unit and the
PFP feed units from the copier
4.1 Perlodic Inspection Check List
Symbols used in the periodic inspection check list
(A) Cleaning with alcohol
(P) Cleaning with heat roller
cleaner(RC60)
Cleaning with soft pad,
cloth, or cleaner
(vacuum cleaner)
(D) Cleaning with a slightly
damp cloth
Customer's
name
Machine
No.
Inspector
Remarks
(100)Every 100,000 copies
(200) Every 200,000 copies
(400) Every
Same thereafter
( ) Replace in event of
deformation or other
damage
(V) Vacuoline
(L) Launa 40
Application
(SI) Silicone Oil
(W) White grease(Molycoat)
(M) Molytherm
Cleaning Lubrication Replacement Date