TORXUN AUTOPED M10S.0028, Руководство по установке, Страница: 61 / 82

Autoped Installation Manual rev 2.0 (100722)
61
Error No Description Cause Elimination Checking time Reaction
E4 01 Reference
switch Range of operator detected
in the Open Position
•
Check:
o
The connection
o
Switching the point of
the reference switch
•
Reference switch must be
activated in closed position
(switch contact to open)
Open position F
02 Not detected in the Closed
Position Prior to the first
setup run A
03 Not detected in the closed
Position
04 Not detected in the open
position in “INVERS” mode
•
Before start (teach) door must
be in open position
•
Reference switch must be
activated in open position
(switch contact open)
E5 00 Power
limitation Control overload
•
Check/correct:
o
Friction of the
Door/Gate
o
Pre-load of closing
spring
•
Ensure maximum door weight
is not exceeded
Permanent A
Maximum power is restricted
E10 01 Full teach
required Parameter Ao, Rod, Invers
or dAxis was changed Carry out a learn cycle Upon changing the
drive unit
configuration H
02 Minimum opening angle has
not been achieved Check the locking/ electric lock During teach H
E11 01 Half teach
required
(opening) Parameter Vo changed Carry out a complete and
unhindered opening cycle Upon changing the
speed parameters W
02 Half teach
required
(closing) Parameter Vc or ForceSlam
changed Carry out a complete and
unhindered closing cycle