TORXUN AUTOPED M10S.0028, Руководство по установке, Страница: 41 / 82

Autoped Installation Manual rev 2.0 (100722)
41
X.1 ELECTRIC LOCKS AND STRIKES SETUP
For wiring of the locks and strikes, see Fig XIV.2d (1, 2), and Fig XIV.2e (1, 2) in Section XIV Terminal Connections and Wiring
Schematics, p.71, p.73.
When setting up an electric lock, all the needed settings can be found in the configuration menu of the AutoPed controller. The
following are the settings that you will need.
NOTE:
When setting up fail safe and fail secure locks, the difference is in the wiring of the locks not the settings. The settings will apply
to all electric locks and strikes including mag locks.
STEP 1 Click the joystick next to the LCD screen in to enter the menus section.
STEP 2 Using the joystick, toggle down to the Config menu.
STEP 3 Press the joystick in to access the configuration section.
STEP 4 Using the joystick, toggle down to the s
ection “Unlock”
•
Set unlock to Permanent; refer to Section XII.6 on p.55 for additional information
STEP 5 Using the joystick, toggle down to EL
– Fb (Electric Lock - Feedback)
•
Set EL-Fb to N.C.; refer to Section XII.6 on p.55 for additional information
STEP 6 Using the joystick, toggle down to LockAu (Lock Automatic)
•
Set LockAu to lock; refer to Section XII.6 on p.55 for additional information
STEP 7 Using the joystick, toggle down to LockEx (Local Exit)
•
Set LockEx to lock; refer to Section XII.6 on p.55 for additional information
STEP 8 Using the joystick, toggle down to LockMa (Lock Manual)
STEP 9 Set LockMa (Lock Manual) to lock; refer to Section XII.6 on p.55 for additional information