TORXUN AUTOPED M10S.0028, Руководство по установке, Страница: 11 / 82

Autoped Installation Manual rev 2.0 (100722)
11
C. GENERAL REQUIREMENTS FOR INSTALLING THE AUTOPED
1. Important : The AutoPed requires that the Door/Gate rest against some type of actual stop in the closed position. The unit will self-
check the closed limits by attempting to close past the closed limit. If the unit does not sense the resistance of a stop, a locking device,
or a door jamb, etc., the AutoPed will go into a soft shutdown.
2. The AutoPed cannot be installed on a Double acting door: a door that swings both in and out.
3. TORXUN recommends installing the AutoPed on Door/Gate headers measuring four inches
(4”) or more in height.
4. For installation on headers less
than four inches (4”) in height, TORXUN requires the use of the StiffenerPlate or equivalent to add
rigidity to the installation of the operator; refer to Sections II.1 and II.2.
D. RECOMMENDED TOOLS FOR INSTALLATION
•
Hammer
•
Center punch set
•
Portable power drill and bits (1/16
”, 1/8”)
•
Micro flat head screwdriver
•
Flat head screwdriver ( 2mm)
•
Philips head screwdriver #1
•
3mm Allen key
•
5mm Allen key
•
6mm Allen key
•
Wire stripper
•
Level gauge
•
Wire nuts 22~14 gauge
•
Masking tape
•
Ladder or step stool
•
Zip ties